PureLink PT-IPAV-E2-RX
2K HDMI IP Extender Receiver
- Transmission of HDMI via IP up to 120m with Cat.5e/6 cable
- Supports resolutions up to FullHD / 1080p
- Use as extender (120m), splitter (1×255), switcher (64×1) and matrix
- Channel-LED, channel selection button, bidirectional RS232, IR pass-through
- PoE or power supply, intuitive GUI software and browser support
Description
PureTools PT-IPAV-E2-RX – IP to HDMI Extender Receiver
PureTools IP to HDMI Extender Receiver – For back conversion of Ethernet AV signals to HDMI signals.
This is the receiver unit as a supplement to the PT-IPAV-E2-TX transmitter.
Multicast, PoE and RS232 Support
AV over IP – Use proven Ethernet 100Mbps network technology to transmit AV signals!
The PureTools PT-IPAV-E2 offers four display modes: one-to-one, one-to-many, many-to-one and many-to-many, offering a choice of 16 pre-programmed channels. Additional channels can be added as required. An almost unlimited number of transmitters or receivers can be integrated into each channel.
With the PT-IPAV-E2, AV resolutions up to FullHD / 1080p@60Hz can be transmitted over a distance of 120m via Cat.5e or Cat.6 with an average of 15Mbps – The codec used is H.264.
The receiver has an integrated RS232 interface, which can be bi-directionally controlled from both sides.
There is also a push button switch for channel selection, including a digital display on the front of the unit – for easy access in difficult installations.
The built-in IR forwarding function allows control of a connected device from a remote location – Optimal when the IR signal is to be sent back to the source device against the AV signal direction.
To power the PT-IPAV-E2 Extender Set, seperate power supplies or Power-over-Ethernet (PoE) can be used.
Additional information
| Brand | |
|---|---|
| Connection Type | |
| Protocol / Standard | |
| Maximum Resolution | |
| Signal Type |
